Parts and Labor until 2015

1988 Supra Turbo – Parts, Mods, Machine Work with Notes on Needed / Wanted (up until 2015)

 

AC retrofit

 

receiver drier, o-rings, etc. (compressor attached and system charged) ($81)

labor ($120)

 

Body, exterior, interior & trim

 

Kaminari ft & rr bumper covers ($696)

Carbon fiber hood ($599)

Paint, lifetime with extra clear (Porsche code 6B4, Seal Gray Metallic) ($3511)

Cobra Evolution GT Seats – 2 ($2672)

Recaro sliders & brackets (included above)

Schroth, DOT approved, 6 pt harness – 2 ($603)

Windshield, new installed ($173)

every bolt taken off car has been measured (see Fastenal, under misc)

gas tank, dipped & cleaned, no sealer ($145)

fire extinguisher

engine undercover ($173)

front emblem (see Misc, below)

TMS front grill screen (NOT USED - $133)

TMS carpet ($255)

Leather steering wheel wrap

TMS Harness bar ($390)

Lipp intercooler block off

clear corners (front turn signal lenses) ($158)

tail light gaskets – replaced with OEM (see Misc, below)

Rubber seal, rear deck lid (see Misc, below)

Interior, sound mat – Dynamat, 2 rolls ($200)

Underbody, stripped, truck bed liner applied

Car cover – used for two weeks at paint shop. not used in garage ($100)

w/strip, trim and adhesive ($77)

 

Need: boot, handbrake, leather, black

 

Brakes

 

Brake pads, Axxis Ultimate, ft & rr ($130)

emergency brake shoes ($135)

rebuilt calipers – 4 ($200)

caliper rebuild kits – 4 on the shelf, mine were too far gone to use ($74)

slotted rotors – 4 ($300)

Earls brake line kit ($110)

Speed bleeders ($39)

Motul HP brake fluid ($27)

 

Clutch

 

Clutchmasters TURBO aluminum flywheel ($355)

Clutchmasters cover, disk & bearing ($599)

 

2nd clutch cover, disk & bearing (stock replacement) *1

pilot bearing (bush) *1

slave cylinder, rebuild kit (for R154) ($14)

steel braided clutch line ($55)

slave cylinder, new, for W58 (FOR SALE)

 

Cooling

 

all hoses (Toyota $1358.86, est. in 2006)

obtained elsewhere, as available

new hose clamps everywhere

inter cooler & heater core, dipped & cleaned ($255)

radiator, replaced ($188)

dual electric fan kit ($235)

 

Engine (early block and early crank)

 

HKS 2.0 mm Bead Type MHG ($244)

ARP head studs ($116)

ARP rod bolts ($50)

ARP main bolts ($136)

K&N filter & recharge kit (kit@$10)

Assembly lube, sealer & slick ($50)

cams, new, after head straightening ($352)

valve stem seals ($40)

valve tool – Mac Tools ($59) (exception to rule about tools in this list)

Adjustable Cam Gears (AEM 23-613C) ($328)

clear timing gear cover ($139)

Valve cover screw kit

exhaust studs enlarged

O2 sensor ($45)

pistons, cast (FOR SALE) – one over ($197)

pistons, forged, with rings (JE) ($891)

timing belt ($160)

tensioner ($34)

oil pump, Toyota dealer ($180

oil squirters, and bolts (sq@$80)

braided hose kit, oil pump ($60)

bearings, rods/mains & seals ($365)

2nd set bears & seals

piston pin bushings (do not remember why) ($10)

thrust washers ($17)

piston rings (2 sets) (1@$84)

freeze plugs, all (see Misc, below)

cam bearing (to be pressed in block after dip) ($49)

water pump *1

thermostat *1

radiator cap *1

air filter (OEM type) *1

fuel filter

oil filter *1

plugs *1

plug wires *1

full gasket set *1

Unorthodox Racing (Suprastore.com) crank pulley, aluminum ($191)

belts, all for original *1

belts, all for aluminum crank pulley

motor mounts – 2 ($172)

flywheel, original, exchanged for rebuilt (FOR SALE) ($57)

 

*1 – Original Parts Order – Rising Sun AP ($999) See receipt, above not inclusive list

 

Need: flywheel bolts, Toyota anti-freeze, red and valve springs

Tool Req’d: re-threading kit (chase)

 

Electric

 

wiring harness, well preserved, wrapped with 550 injector clips ($120)

alternator ($130)

starter ($75)

Optima Redtop GEL battery, on battery tender ($185)

Taylor Aluminum battery box, relocation cables ($191)

battery dis-connect

Sealed beams – 2 ($50)

Turn signal stalk replaced (used, $85)

painted arms, installed new blades, ft. & rr.

4 - Focal Acess speakers, 100 GA1SG, ft. & rr ($250)

 

Need: Gauges for turbo functionality, and mounting locations

Boost (20-25 lbs)

EGT

Air/Fuel Ratio (Wideband 02)

Water Temperature

Oil Pressure

Oil Temperature

 

Like: aftermarket wiring harness, will hold off until too late and NLS :(

 

Exhaust

 

Front pipe without front cat ($240 estimate)

High Flow Catalytic Converter ($99)

Blitz NUR Spec Exhaust (Cat back) ($740)

 

Also have entire original exhaust taken off in 2005, in case SMOG is possible.

 

Fuel

 

Turbonetrics 60-1 2.75" stage 3 turbo with ceramic bearing ($1345)

CT-26 (FOR SALE)

Aeromotive Fuel Pressure Reg ($135)

Walbro 255lph fuel pump ($105)

RC engineering 550cc injectors ($425)

Wiring clips ($48)

Greddy RS BOV ($219)

Greddy Full Auto Timer ($150 estimate)

Lipp Lexus V8 AFM ($225)

hard pipes, all, perhaps, all plus a few duplicates (1@$85)

 

Need: wideband o2 - sensor and something to tune with.... (10/17)

 

Suspension

 

Eibach Pro-Kit, Springs (EIB 8211.140) ($223)

Illumina adjustable shocks, ft & rr ($430)

sway bars, ft & rr ($220)

link assembly, pairs, ft & rr ($292)

KYB strut boots – 2 ($30)

KYB front strut/strut mounts – 2 ($83)

KYB rear strut/shock mounts – 2 ($93)

Cusco rear strut tower bar ($149)

Cusco front strut tower bar ($149)

tie rod ends – 4 ($334)

ball joints – 2 (included above)

bearings & seals, spindles

bearings & seals (WAM, some duplication or error, forget why)

wheel studs – 4

Lipp, red poly bushings, ft & rr ($170)

machine shop pressing ($720)

Lipp traction bars – came with poly bushes ($330)

Original traction bars with poly bushes (FOR SALE)

4 – 225/50R16 Goodyear F1 Eagles ($668)

4 – Kosei RT Double Racer wheels ($739)

lug nuts

locks

 

Need: TEMS, front only, have rear

Identify: Nuts, rear sway bar link (not 10 x 1.25; but, very close) Special ordered: dealer 1/18

 

Missed: sub-frame nylon bushes (not known to need, just unfortunate to have missed)

 

Transmission (R154 5 speed)

 

Trans mount ($41)

rear seal

new fluid

short throw shifter ($330)

drive shaft. one piece, light ($379)

 

Rear End (LSD confirmed)

 

Rear half shafts, axels (rebuilt) ($104)

differential fill bolt

LSD gear oil, replaced

U-Joints – 3 (PN 1-1612BF FOR SALE) ($57)

 

Miscellaneous (from receipts)

 

Grommets – Special Order from Toyota ($19)

Fastenal – all nuts and bolts ($337)

More Fastenal ($17)

Holder, fipg & sundry kit – SO from Toyota ($62)

Cylinder SOPR – SO from Toyota ($18)

Brake parts, springs, cups, pins – SO from Toyota ($27)

Springs, pins & cotter – SO from Toyota ($33)

TL gaskets, hatch seal, freeze plugs, ft. emblem & other SO Toyota ($574)

Plug & gasket – SO from Toyota ($5)

More small parts – SO from Toyota ($30)

 

Machine work done

 

Hot tank, block

surface block after two spots welded

cylinder boring & cross hone

head straightened & surfaced

valve seat grinding

valves refaced

above done at Wholesale Automotive Machine – San Diego ($876)

 

Machine work still to be done prior to final assembly

 

align bore big end of rods with ARP bolts

align bore crank with ARP mains

balancing

 

Welding to be done

 

front seat mounting nut, in floor

bracket for front facia attachment

 

Additional Parts obtained follow:

 

Competition Cams Inner Value Springs for Big Block Chevy (PN 975)

ARP 4age flywheel bolts (Titan, Rich) 8 pcs m10x1.25 203-2802 ($27)

f/p block off plate for Big Block Chevy (Summitracing.com)

 

Parts Needed from Wrecking Yard

 

clip for driver’s door locking mechanism

clip from left lower door seal

driver’s door vent grill

lower dash panel (beneath steering wheel)

Speedo trim panel

TEMS units for front struts (2)

 

Catch Can (http://www.eliteengineeringusa.com/Catch_Can.thml)

 

The speakers were listed under electric because they were purchased early and wired in sealed OEM speaker boxes and using the original through the door harness wiring. Care was taken to assure speaker synch or polarity for the connections. The dash harness remains disconnected, so any additional ground requirements have not been addressed. New additions to the list: Panasonic head unit, Boss amp and appropriate wires and connections. Car has remote battery and central ground location is TBD. The list has been maintained without any price additions. Notable items included or removed due to ECU and digital dash projects.

 

Original Purchase Price from Kars4Kids was $525 plus $190 towing.

$32,458 Total spent to date (tools & supplies not included) costs up to October 19, 2015

 

This car is libel to never be legal in California. Several parts are marked “off road use only”; although, they could be taken off. It would still never pass a visual inspection. I am counting on a miracle, or perhaps a move into Nevada :)

See the next tab (electronics) for more current details